Where do these go?!

[RedMerle]

When I refinished my first Trophy last summer, I replaced most of the bolts with stainless steel, including these two (very distinctive) tapered head bolts.

I can remember where they were fitted. Who recognises them?

[digital]

Only two screws go in the Trophy?

[RedMerle]

Quite a lot more than two! 

[sin_tiger]

M10 x 1.25 pitch is metric fine for high torque, most commonly used on frame fixings or brake caliper to fork / swing arm etc. but I can't think of or find any that are 60mm on the TTSE, I don't have a searchable parts list though so not definitive.

[digital]

Interesting!

[Coconut]

Is this a Competition ?    Is there a Prize ? 

The only M10 x 1.25 bolts that are 60mm long that I can find,
are the two bolts securing the Rear Torque Arm ( T3205760 ),
but these have standard Hex Bolt Heads, not the tapered version in your Photo.

sin-tiger : "I don't have a searchable parts list though so not definitive."

Yes you do ! - So does every other Forum Member :

Spare Parts List - Click the Link in the First Message to download my version of the Parts List
in Excel Spreadsheet format - with updated Part Numbers and alternatives where known !

Cheers 

[sin_tiger]

Originally Posted by Coconut

The only M10 x 1.25 bolts that are 60mm long that I can find, are the two bolts securing the Rear Torque Arm ( T3205760 ),

That would make sense.

Originally Posted by Coconut

but these have standard Hex Bolt Heads, not the tapered version in your Photo.

The ones shown in the photo are aftermarket "Probolt", so it's entirely possible.

Originally Posted by Coconut

Yes you do ! - So does every other Forum Member :

Spare Parts List - Click the Link in the First Message to download my version of the Parts List
in Excel Spreadsheet format - with updated Part Numbers and alternatives where known !

Thank you, that got uploaded while I was not keeping up 

[RedMerle]

Thanks for the replies.
I’ll confirm where they are when/if I find out