Engine management light

[stnrsbrian]

 Hi all I’ve just replaced my battery ( the old was 7 years old ) now I have an engine management light on after starting 

[Coconut]

It's not unusual for the Trophy to throw up an error code or two after Low Voltage.

In particular "P1698" : "5 Volt sensor supply circuit malfunction" will often be logged.

It's easy to check any Error codes that have been stored,
and have them displayed on the Instrument Panel :

Press the SCROLL UP and SELECT ( "i" ) buttons together,
and hold them in while switching on the Ignition -
Keep them held in until the Speedo and Tacho needles have completed their Sweep

The screen should display "DTC" ( Diagnostic Trouble Codes )
with any DTC's that have been stored listed underneath.
If there are more than one, use the Scroll button to scroll through them.

"P0000" is what you wart to see - it means there are NO DTC's stored.

Make a note of any DTC's ( take a Photo ) and Switch the Ignition OFF when done.

Refer to Reply #8 dated Mar 11, 2015 titled "Diagnostic Trouble Codes ( DTC's ) / Fault Codes" in this Topic :

Servicing Data, Reference Info. & DTC ( Fault ) Codes
for more information and a downloadable document listing all of the DTC's with their meanings,
and further information such as how many "No Fault" starts are required before the "MIL"
( Malfunction Indicator Light / Engine Management Light ) is extinguished,
and long they are held in Memory before being automatically cleared.

Report back with any DTC's that you find if you need further advice 

Cheers 

[stnrsbrian]

Many thanks coconut 

[pjhprop]

Had the same problem with battery failed at petrol station and wouldnt start. long story short the good people of Filey help me to start bike using spare battery and jump leads. Managed to get back home without issue engine management light on all the time. Fitted new battery fauly code P1698 showing. started several times and the engine management light is no more.

[Noggin]

Or rather than wait use the excellent dealertool/tigertool soft ware and obd connector ( I mention both, because I can't remember which one i used recently when my battery died)