Size of clutch slave cylinder's seal

[Alex Gun]

Hi gents!

I looking for the size of clutch slave cylinder's seal.

Yes, repair kit is accesible (for exp. here https://www.ebay.de/itm/303912146185) , but really needed only seal.
I had the same issues with my previuos Capo etv1000 and I have a possibility to produce EPDM seals (compatible with DOT fluid).

Thank you in advance.

BR
Alex

[digital]

I hadn't seen this post, so I don't know if he's already got the measurements. In any case, I am providing the measurements in case someone else needs them.
The retainer (seal) is used, but it does not look too worn or curved so that the measurements have changed from a new one.

[digital]

Before I left this other photo in the inkwell and maybe that reference can be valid for you.

[Alex Gun]

Thank you very much !

Did you change it?

[digital]

No I have not replaced it, remove that seal from a slave cylinder to take measurements for you.

It is the slave cylinder that I always carry when I go on a trip.

I assume you know how to remove the seal without taking any damage?
To extract the seal (retainer) I always inject air through the purge nozzle with the compressor and the gasket comes out by itself.

[trophied]

Hydrapac Italia lists that exact seal by the size shown on it and the specifications for it.  Might be able to order it from them if it's difficult to find.  they have partners all over Europe as well as some in the rest of the world.

[Alex Gun]

Very important is type of material.

[Alex Gun]

 

Originally Posted by digital

No I have not replaced it, remove that seal from a slave cylinder to take measurements for you.

It is the slave cylinder that I always carry when I go on a trip.

I assume you know how to remove the seal without taking any damage?
To extract the seal (retainer) I always inject air through the purge nozzle with the compressor and the gasket comes out by itself.

 
 
Tnx one more time!