* Recent New Topics

Front Wheel Bearings by nert
[Today at 02:03:12 am]


Rear Wheel Studs - Dimensions by STJIM
[Today at 01:56:36 am]


New Member by TrophyRider4
[Today at 01:27:01 am]


Does anybody know of any good Black Friday deals on tires? by Saddle Tramp
[Yesterday at 11:26:35 pm]


Author [ES] [PL] [PT] [IT] [DE] [FR] [NL] [DK] [SE] [FI] [NO] Topic: Homemade Bar Risers  (Read 25252 times)

0 Members and 1 Guest are viewing this topic.

Offline Novocastrian

  • Trophy Pro
  • ***
  • Posts: 489
    • View Profile
  • Bike: TTSE
  • City / Town: Tynemouth
  • Country: UK
Re: Homemade Bar Risers
« Reply #48 on: November 17, 2020, 11:28:58 am »
I haven't read the whole thread but the risers I removed were made specifically for the job (the Trophy). You could tell by the machining involved.  I removed them and sold them on because a) I didn't need them b) I wasn't happy about the strain they put on to the already known harness problem.

However, I bought the bike from Demonbane up in Scotland (still in this group I think) and he would have bought the risers from new and would be able to tell you the supplier (if he's still here and contactable)
Ken Hastie
TTSE, a handful of BSAs and an MGB

Offline Saddle Tramp

  • Trophy Master
  • ****
  • Posts: 801
  • Have Trophy, Will Travel
    • View Profile
  • Bike: 2015 TTSE - Black
  • City / Town: N. WI / S. AZ
  • Country: USA
Re: Homemade Bar Risers
« Reply #49 on: November 17, 2020, 02:34:27 pm »
There is no rule that the spacers have to be 1” in length.
When I bought my new Trophy in 2018, I decided to add 3/4” spacers instead of 1”, over concerns about wiring and cable interference. I of course sized the new bolts to match the spacers.

I can happily report that they have performed flawlessly over the last 33,000 miles.
Plus, they didn’t create interference with the Triumph tank bag, back when I had the one.
Probationary Twisted Trophies Member (Non-Texan)

 



tweedy-bunch