On my previous Trophy I had several of the Panels protected with 3M Film.
The ( UK ) Company I used was :
Tony James Designs ( Tony Hill )
Tony did a FANTASTIC job, covering many more Panels than the Triumph Kit,
and at a cheaper price ! - See below images.
I haven't spoken to Tony for a good while but I'm sure he will still have the Templates
that he made for my Trophy, so would be able to produce more if requited.
Whether he can ship to the US or not I don't know - but it might be worth asking !
If you do make contact with him, tell him I said "Hi" !
Photograph taken just after completion of the work,
( Polishing was included as part of the service

) :

The next picture shows the various panels that have been protected with the film :

1 & 2 = Left & Right panniers ( Where your boots scrape + Leading edge protected against stone chips ! )
3 & 4 = Left & Right fuel tank sides ( Where your legs rub ! )
5 & 6 = Left & Right Upper Fairing
7 & 8 = Left & Right Centre Fairing
9 & 10 = Left & Right fuel tank leading edges
11 & 12 = Left & Right Lower Fairing
13 & 14 = Left & Right underbelly pan
15 & 16 = Left & Right fork covers
17 = Mudguard ( Fender

)
The lower fairing and underbelly pan pieces
could have been made as one piece,
but Tony recommended splitting these as the underbelly pan piece is the most likely
of all to get damaged over time ( being the closest to the road surface ),
making it a cheaper and simpler task to replace just that smaller piece if ever needed - top bloke

