Front Daytime Running Lights

[digital]

Permanent after the key, you can take the voltage from the rear cigarette lighter socket or from the rear position light.

If you want permanent voltage with the motorcycle stopped and without turning on the ignition key, you can take it from the fuses under the seat.

[louping77]

 I found  it many thx
 
 

[digital]

Here is the schematic requested so that only one day-night cell control module can have, the daytime led lights and the handlebar buttons illuminated.

[louping77]

Originally Posted by digital

Here is the schematic requested so that only one day-night cell control module can have, the daytime led lights and the handlebar buttons illuminated.

Hi thx so much for diagram
Does i need to use switch ?
Can use only the sensor?

[digital]

The switch is only for the daytime led lights.

[louping77]

They can t Works without switch?
Because i will use sensor for
Pinapple, and daytime

[digital]

If you want to disconnect and connect the daytime running lights, it is obviously necessary to place a switch. For the led light on the handlebar buttons, no switch is necessary.

In the last schematic that I have created, it is clear that the switch is only for daytime running light, but I have designed the control module for daytime running light and light on handlebar buttons.

Thus, the module is two in one.

[louping77]

Ah ok
My goal was to run both
On same sensor , sorry for misenderstood
Anyway ill use the daylight as coconut one
And also illuminate my pinapple