Installation Led's intermittent in the mirrors of the Trophy

[trophied]

They mimic the indicators on automobiles in the US these days.  They all have those on the outside mirrors to alert drivers that may be in the blind spot.  May even be a government requirement here now since ALL the current vehicles have them.  Drivers here now seem to think if they signal they're entitled to that position on the roadway, no matter if it's partially occupied already or not!  They can't see past their hood ornament and think their rear bumper is just behind the driver's seat!

[louping77]

Originally Posted by digital

It is important to replace the original cables with others of better quality, since they are broken by the part that is welded to the circuit.

Hi Digital i replaced original wires
And also welded some news with connectors
Better  looks too

Above all, place male / female connectors to be able to disconnect them.

No, GarminDave. When they are stopped, the LEDs are not visible in adsolute. The mirror itself does not allow any LEDs to be seen.

[digital]

Originally Posted by trophied

They mimic the indicators on automobiles in the US these days.  They all have those on the outside mirrors to alert drivers that may be in the blind spot.  May even be a government requirement here now since ALL the current vehicles have them.  Drivers here now seem to think if they signal they're entitled to that position on the roadway, no matter if it's partially occupied already or not!  They can't see past their hood ornament and think their rear bumper is just behind the driver's seat!

Some time ago I posted a trick on this forum that I had the same system installed on my motorcycle. With a control center and two sensors inside the two suitcases

[louping77]

 This is my Leds intermittent  in the trophy
 thanks Digital for his precious tutos :




 

[digital]

Originally Posted by louping77

This is my Leds intermittent  in the trophy
 thanks Digital for his precious tutos :

 

[louping77]

Hi all
my request is , if i plug the led's intermittent wires form mirrors
on the OEM intermitents terminals does it needs  resistors?
or does the resistors already in place will do the job?
 


:

[digital]

You don't need resistors, if you put resistors, the light will hardly be seen.

Simply connect the positive of the mirror led lights to the positive of the OEM turn signal and the negative of the mirror led light to the negative of the OEM turn signal.

[louping77]

 Hi Digital
 ok many thanks
 have a nice evening